(Figure 12)
12. It is time to create branches. The branches are created by 2 cylinder then add lattice to both and twist them together. Pull CVs is needed to fine-tune the shape. (Figure 12)
(Figure 12)
13. Some small branches is put together with the main branch. After Putting the branches together. I get the picture below. (Figure 13)
(Figure 13)
Now, I will use NURBS circle to model the window. First I create 1 NURBS circle, then I duplicate and scale it. Glass surface is formed by go to Surface, Planar. The tree surface is lofted and pull the CVs into the shape I want. Lastly I create a small NURBS circle to extrude it along the glass to form window cane. Besides this, few cylinder is add to the middle of the glass. (Figure 14)
(Figure 14)
15. After that, I put the window to the tree and add in some small gadget. Then I model the door with the same tools. The picture is shown as below. (Figure 15)
(Figure 15)
email : keongputer@hotmail.com